Anritsu MP1763B
Pulse Pattern Generator 12.5Gb/s
Description
The MP1763B is used in combination with the MP1764A Error Detector. The amplitude of the clock and data signals can be varied from 0.25 to 2 Vp-p while the offset can be adjusted to within ±2 V so that the amplitude and the offset margin can be measured.
The clock has a
variable delay function so that time-dependent characteristics or
phase margins of the input clock and data can be measured. An M
series pseudorandom pattern representative of actual conditions or
a programmable pattern can be selected as cell data.
In addition, a 3.5 inch floppy disk drive is built in for storing preset
data, enabling rapid measurements to be performed by simply pressing a key.
A GPIB function is provided, enabling automatic or remote
measurement via an external controller.
The MP1763B is a pulse pattern generator ideal for research and
development of high-speed logic, ICs, and digital systems.
Key Points
High quality waveform
Low FM/PM-noise clock generator
8 Mbit programmable pattern corresponding to six frames of STM- 64/STS-192
Generates PRBS patterns with bit length from 27–1 to 231–1 bits
Complementary outputs of both data and clock
The amplitudes and offsets of all 8 data outputs that have 1/8
speed of fundamental clock signal can be set
Specifications
Operation frequency:
Internal clock:0.05 to 12.5 GHz (option)
External clock:0.05 to 12.5 GHz
External clock:
Input level:0.4 to 2.5 Vp-p
Input waveform:Square wave with rise/fall time of less than 1 ns, duty factor 50% (0.05 to 0.5 GHz); Sinusoidal wave with rise/fall time of less than 1 ns, duty factor 50% (>0.5 GHz)
Input connector:APC-3.5
Internal clock:
Frequency range: 0.05 to 12.5 GHz (option)
Frequency setting resolution :1 kHz, 1 MHz
Stability:±1 ppm
SSB phase noise (at 10 kHz offset, 1 Hz bandwidth):–85 dBc/Hz (0.05 to 4 GHz), –80 dBc/Hz (4 to 8 GHz), –75 dBc/Hz (8 to 10 GHz), –70 dBc/Hz (10 to 12.5 GHz)
Reference signal :10 MHz (internal/external, selectable)
Data output:
Output waveform :NRZ
Number of outputs: 2 (DATA/DATA)
Amplitude:0.25 to 2 Vp-p, 2 mV steps (setting error: ±15% or ±100 mV, whichever is greater)
Rise/fall time: Typical 30 ps (10% to 90% of amplitude)
Pattern jitter:<=20 psp-p (typical 10 psp-p)
Waveform distortion:<=15% or ²150 mV whichever is greater
Load impedance :50 ohm (with back termination)
Connector:APC-3.5
General:
Operating temperature range :0° to +50°C
Parameter memory:
Media: 3.5 inch FD (2HD, 2DD)
Format: MS-DOS (Rev. 3.1)
Content: Programmable pattern and other parameters
Power:5Vac ±10%, 50/60 Hz, <=700 VA
Dimensions and mass: 426 (W) x 221 (H) x 451 (D) mm, <=33 kg
