Keithley 7011S
Quad 1x10 Multiplier Card
Description
The Model 7011 40-channel multiplexer has four independent banks of 1×10 switching. Each channel is 2-pole. These four banks can be combined for a wide variety of switching configurations—for example, dual 1×20, or 1×10 and 1×30, or one large 1×40.
The 7001 mainframe can automatically configure the 7011 to switch 4-pole signals by combining channel pairs. This gives you a dual 1×10 4-pole multiplexer or a single 1×20 4-pole multiplexer.
Each of the four multiplexer outputs on this card connects to the 7001/7002 analog backplane through removable jumpers for even greater flexibility. Two 7011 cards can be used to make a single 1×80 multiplexer with all intercard connections through the backplane. The 7011 multiplexer outputs can also be
connected to the rows of the 7012 via the backplane for row expansion.
The Model 7111-S is a form C version of the 7011-S. The 7111-S is a low-voltage, quad 1×10, single-pole form C multiplexer card. The 7111-S assembly consists of a screw terminal connector card and a relay card. External test circuits are wired directly to the screw terminals of the connector card.
The 7011S card will automatically configure the 7001 or 7002 mainframe. Two connection options are available; screw terminal for maximum flexibility or a single 96-pin quick disconnect connector.
Key Points
Quad 1x10 multiplexer for 2-, 4-, or 8 pole operation
Connects to 7001/7002 backplane for easy expandability
500nV, 100pA offsets
For General Current and Voltage Multiplexing
Excellent Isolation, Offset, and Crosstalk Characteristics
Specifications
Connector: 96 pin connector
Form factor: Module
Instrument type: Quad 1x10 multiplexer
Offsets: 500nV, 100pA
Maximum DC Signal level: 110V DC between any two pins, 1A switched. 30VA (resistive load)
Maximum AC Signal level: 125V rms and 175V AC peak, between any two pins, 1A switched, 60VA (resistive load)
COMMON MODE VOLTAGE: 175V peak, any pin to chassis