Keithley 228A
Prog Voltage Current Sourc 100V/10A
Description
This Programmable Voltage Current Source is a precision programmable source with the capacity to sink of source up to 100 watts.
Six ranges accurately regulate voltage or currents as determined by the load.
And because it is two programmable sources in one you get the flexibility for a broader range of test setups, without having to buy separate sources.
It is capable of bipolar source or sink up to a full 100 watts without derating, permitting it to act as a voltage or current supply or as an active load.
Key Points
100 watt source or sink
<
p><1ms transient recovery
Low noise
Smooth range changes
Built in voltage and current monitors
Specifications
Output 1,volts/maximum current: 100V to 10A
Total power: 100W
Bandwidth: 5KHz typical
Output resistance: 10k Ohms
Output inductance: 100µH typical
INPUT RESISTANCE: 6.8k ohms
SENSITIVITY: –10V increases magnitude of programmed output by 100% of full scale; +10V decreases magnitude of programmed output by 100% of full scale.
ACCURACY: 2% typical, DC to 60Hz.
MAXIMUM MODULATION: Modulation and programmed setting should not cause operation exceeding the range of 0 to 100% of full scale.
MODULATION FREQUENCY: 600Hz bandwidth.
TEMPERATURE COEFFICIENT (0°–18°C & 28°–50°C):
±(0.1 X applicable accuracy specification)/°C.
OUTPUT RESISTANCE (min.): 10A Range - 10 k ohms, 1A Range – 100 k Ohms, 0.1A Range - 1 M Ohms.
OUTPUT CAPACITANCE: 0.2 µF typical
OUTPUT LOAD: Must be non-inductive.
BATTERY BACKUP: Rechargeable 3.6V nickel-cadmium. 1 month retention of data with unit turned off.
MAXIMUM COMMON MODE VOLTAGE (output or output common to chassis): 100V DC.