Agilent / HP / Keysight 60502B
60502B 300 Watt dc Electronic Load Module
Description
The Agilent / HP 60502B load module along with the DC electronic load mainframe are ideal for the test and evaluation of DC power sources and power components and are well suited for applications in areas such as research and development, production, and incoming inspection.
The Agilent 60502B module includes programming inputs that allow control of load current via an analog control voltage.
The Agilent 60502B is designed for use in a 6060A Electronic Load mainframe.
The Agilent / HP 60502B is ideal for the test and evaluation of DC power sources and power components and is well suited for applications in areas such as research and development, production, and incoming inspection.
The Agilent 60502B module can operate independently in constant current (CC) mode, constant voltage (CV) mode , or constant resistance (CR) mode. In addition, each input can be turned on or off (open circuit) or short circuited.
The 60502B module includes programming inputs that allow control of load current via an analog control voltage.
In the 60502B, power connections are made via large high current binding posts that permit rapid connections by hand and eliminate the traditional bolt/nut connections of the past.
Programs written for the Agilent 6060 series of single Electronic Loads can be used with the multiple loads, easing program development for applications using various members of the Agilent Electronic Load family. (Triggering via the ac line frequency or the load's internal timer is available only in the multiple load mainframe.)
The 60502B load module can be individually controlled either via GPIB or locally via the front panel. Once a channel is selected or addressed, all subsequent commands go to that channel until another channel is selected or addressed.
Operation of all models is similar, regardless of power ratings. If any application requires a greater power or current capacity than one module can provide, the Agilent 60502B load modules can be connected in parallel in CC or CR mode.
Key Points
Analog voltage control in constant current mode
Full protection from over-current, over-voltage, overpower, over-temperature, and reverse polarity
Parallel units in constant current mode for higher power
VXI plug&playdrivers
Specifications
Form Factor: Module (proprietary interface/bus)
Type: DC
Maximum Power: 300 Watts
Minimum Voltage: 3V
Maximum Voltage: 60V
Maximum Current: 60A
Current Ripple and Noise: 4 mA rms
Voltage Ripple and Noise: 6 mV
Analog programming bandwidth: 10 kHz (-3 dB frequency)
Net weight: Approx. 3.2 kg (7 lb)
Shipping weight: 4.5 kg (10 lb)