Agilent / HP 1160A

This unit is a small, rugged, general purpose probe for use with the 54810A, 54815A, 54820A and 54825A Infiniium Oscilloscopes.

This unit is fully compatible with the Agilent AutoProbe interface which completely configures the Agilent Infiniium Oscilloscope for the probe.

It is built and tested for high reliability.

The cable has a Kevlar strengthener for added pull strength.

The general purpose retractable hook tip is made from a durable music wire and probe tips are replaceable.

This unit comes with a wide range of accessories including an Agilent Browser that installs over the probe tip.

The Browser utilizes a crown point pogo pin that digs into solder and absorbs small hand movements, so is less likely to slip.

There is also an alligator lead for general purpose probing, 4 spring grounds for high frequency measurements, a socketed ground lead and IC clips for probing surface mount devices.

The handle of the probe can be removed, leaving a miniature probe body with a narrow and sharp tip ideal for probing dense circuit boards.