Tektronix SG502
Oscillator 5Hz to 500KHz
Description
This Oscillator is to synchronize this SG502 with an external oscillator.
Synchronization is done by plugging the sine wave output of the external oscillator into the SYNC INPUT jack on the front panel.
Attempting synchronization with other than a sine wave may cause harmonic distortion of this unit's output.
Maximum purity is obtained when both signals are the same frequency.
The frequency range over which the synchronization occurs depends upon the amplitude of the synchronizing signal.
The voltage required for synchronization varies linearly from 0 V to approximately 5Vrms.
Key Points
5Hz to 500KHz Sine and Square Waves
Extremely Low Distortion Sine Wave
5VRms Open Circuit is 600Ω Source
0 to 40dB Output Variable Plus 0-70dB in 10dB Steps
Specifications
Frequency Range: 5Hz to 500KHz
Input Impedance: 10KΩ
Calibration Accuracy: 5%
Amplitude Response: Within 0.3dB
Maximum Output Voltage: 5Vrms
Variable Amplitude: 0 to >40dB
