Agilent / HP / Keysight 200CD
200CD OSCILLATOR
Description
This unit provides higher output power than most solid state oscillators and offers good frequency coverage and stability.
With its 2V open circuit, and 10V balanced output into 600ohms impedance, it has the power to drive most circuit applications without the need for an additional amplifier.
The frequency adjusting dial, with 0.5% increments and 2% calibration accuracy, eliminates the need for a frequency counter.
A dial vernier allows precise adjustment of the needed frequency, from 5Hz to 600KHz.
Key Points
Frequency range: 5Hz to 600KHz (5 bands)
Dial accuracy: ±2%
Flatness (1KHz, ref.): ±1dB
Output voltage: (600ohm load) 10V RMS (> 160mW; (open circuit) 20V RMS Output impedance: 600ohms
Attenuator: Continuously variable
Distortion: (5Hz to 20Hz) <0.5%; (20Hz to 200KHz) <0.2%; (200KHz to 600KHz) <0.5%
Hum and noise voltage: <0.1% of rated output
Balance: <0.1% at lower frequencies approximately 1% at higher frequencies
Specifications
Frequency response 5Hz to 600kHz in five bands.
Accuracy +/- 2%. But these days just set the output frequency with a digital counter.
Frequency response +/- 1dB, referred to the 1KHz output level.
Output maximum level 20v open circuit, 160mW (10v) into 600 ohms.
Distortion: 0.2% from 20Hz to 200kHz
0.5% from 5Hz to 20Hz and 200KHz to 600KHz
The output is designed to match a 600 ohm impedance, and can be used balanced or unbalanced.
